If you’re looking for a replacement gear shifter lever for your 2008-2010 Ford F-250 Super Duty, F-350 Super Duty, F-450 Super Duty, or F-550 Super Duty with an automatic transmission, look no further than this genuine automatic transmission steering column gear shifter lever.
Installation Instructions:
Tools Needed:
- Socket Set
- Torx bit set
- Screwdriver
- Pry tool
Skill Level: Intermediate
Installation Time: Approximately 1-2 hours
Note: Before starting the installation, ensure that the battery is disconnected to prevent accidental airbag deployment.
- Use a pry tool to carefully remove the steering column trim covers to expose the steering column and gear shifter lever assembly.
- Locate the wiring harness connector for the gear shifter lever assembly and disconnect it by pressing down on the locking tab and pulling the connector away from the assembly.
- Use a socket set and Torx bit set to remove the bolts and screws securing the gear shifter lever assembly to the steering column.
- Carefully remove the old gear shifter lever assembly from the steering column.
- Install the new Genuine Ford automatic transmission steering column gear shifter lever by aligning it with the mounting points on the steering column and securing it with bolts and screws.
- Reconnect the wiring harness connector to the back of the new gear shifter lever assembly.
- Reinstall the steering column trim covers by snapping them back into place.
It is important to note that this installation requires intermediate-level skills and should not be attempted by individuals with limited automotive knowledge. The job can take approximately 1-2 hours to complete, depending on the installer’s skill level and familiarity with the vehicle. Always make sure to reconnect the battery after completing the installation.